APEX Failure Resistant Extractor - Glock

I picked up a Failure Resistant Extractor for my Gen4 G19 because I have had it spit cases in my face a few times.  It is my EDC and I figure I should probably stack the deck in my favor, which is exactly what I am doing by purchasing this aftermarket extractor.  But I am not just going to swap it into the gun and carry it without putting a bunch of rounds down range with it installed - I do not trust anything until its vetted properly.  So tomorrow I'll head to the range, swap it there and run it for a hundred or so rounds doing drills.





I'll do physical comparison when I get back.


0 comments:

Post a Comment

My Instagram